| Цепь | Цвет | Расположение | Дополнительно |
| 12 Вольт | Красный (+) | За блоком предохранителей, PASSENGER UNDERDASH | |
| Зажигание | Желтый (+) | Жгут замка зажигания | |
| Зажигание 2 | Н/Д | ||
| Зажигание 1 | Розовый (+) | Жгут замка зажигания | |
| Зажигание 2 | Н/Д | ||
| Зажигание 3 | Н/Д | ||
| АСС 1 | Коричневый (+) | Жгут замка зажигания | |
| АСС 2 | Н/Д | ||
| Наличие ключа | Н/Д | ||
| Габаритные огни ( - ) | Коричневый/Белый (-) | BCM, 18 контактный разъем, Pin 8, | |
| Габаритные огни ( + ) | Коричневый (+) | FRONT of FUSEBOX, PASSENGER UNDERDASH | |
| ЦЗ Закрытие | Красно\черный (TYPE B) | BCM,Разъем C2, Pin 2, | |
| ЦЗ Открытие | Оранжевый/Черный (TYPE B) | BCM,Разъем C2, Pin 11, | |
| LOCK MOTOR WIRE | Серый (5-WIRE TYPE) | BCM, C2, Pin 52, | |
| Двери | BCM, | 7141_GRAND-PRIX_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf | |
| Вежливая подсветка | Серый/Черный (+) | the Подсветка под панелью или BCM,Разъем C1, Pin 43, | |
| Открытие багажника | Голубой (+) | BCM,Разъем C2, Pin 45, | |
| Раздвижная дверь | Н/Д | ||
| Сигнал | Коричневый (-) | BCM, 18 контактный разъем, Pin 9, | |
| Тахометр | Белый (AC) | Зажигание CONTROL Module Pin E, See NOTE #4 | |
| WAIT TO START LIGHT | Н/Д | ||
| Тормоз | Белый (+) | BCM,Разъем C2, Pin 30, | |
| Отключение штатной сигнализации | Фиолетовый (-) | BCM,Разъем C2, Pin 24, | |
| ANTI-THEFT | GM's PASSKEY 3 (PK3 on Steel Shaft of Зажигание Key) TRANSPONDER SYSTEM | TRANSPONDER Замок зажигания TUMBLER |
| NOTES |
| NOTE #1: there are (2) Розовый (+) wires that test as an Зажигание wire, to test for the correct Розовый Зажигание wire. Place the Key in the Замок зажигания but do not turn to the ON position. Try the remote Зажигание, if the KEY in the Зажигание CHIME turns on, you are energizing the correct Розовый Зажигание wire. NOTE #2: the BCM (Body Control Module) is located at the far end of the Drivers Dash, to access remove the Left END of the the Driver Dash it is just snapped into place then remove the under dash panel that is held into place with (3) plastic push-pins. Next remove the lower dash cover, this is held in place with (3) scres, one behind the Left END of the drives dash coverи(2) along the bottom of the dash. Next remove the Steel Knee bolster, it had (4) 10mm bolts that hould it into place on either side of the steering column. Now you can access the BCM, the BCM is hel into place by (3) 7mm screws on the face of the dash panel. The C2 54-pinРазъем for the BCM can be accessed from the Left END cover of the dash, the C1 54-pinРазъемиC3,18-PINРазъем are side by sideиare plugged into the BCMиface the floor of the vehicle, the C, 54-pinРазъем is to the leftиthe C3,18-PIN is to the right. NOTE #3: the Водительская дверь is a Серый/Черный (-) Pin 26, the PASSENGER DOOR is a Черный/Белый (-) Pin 17, the DRIVERS SIDE REAR DOOR is a Голубой/Черный (-) Pin 7иthe PASSENGERS SIDE REAR DOOR is a Светлозеленый/Черный Pin 5 all are at the BCMРазъем C2. When connecting to an ALARM SYSTEM, use all (4) Двери wiresиDIODE ISOLATE. to connect, See Дополнительно NOTE #4: the Зажигание CONTROL MODULE is located on the TOP of the ENGINE, towards the PASSENGER SIDE. |